I know what I have done, but do not know what I did!
I was not satisfied about the resulution I get with my 1:3 ratio so I set down and read the script up and down up and down
as I understand what i was reading.
The worst thing that could happen if i changed something would be that is not...
Hello again!
I was not clear enough in describing.
Steps/rev for motor = 200 set for halfsteps give 400steps/rev and with 1:3 gear need 1200 / rev.
I can see about those even numbers but dont understand yet how it rounds off in the end.
For now when ask for 360deg i get some 324 and hoping to...
Hello all of you!
Sometimes when you see something it says clonk in the head "That should i build".
This was such a thing.
Ordered missed components, draw a nice box and 3d printed it, hooked it up and its working.
BUT!
I use it for my 4th axels thing to my cnc router. 200steps/rot, beltgear 1:3...