1. FEATURED BUILD

    ~ Single cylinder OHV - "Snöffy"~
    Dismiss Notice

BIGTREV's Recent Activity

Help Support HMEM by donating:

  1. BIGTREV liked bmac2's post in the thread Foot Switch.

    Cogsy, I’m not sure but I think that’s about the same return as I get on my savings, after the banks service charges.

    Dec 4, 2019 at 6:28 PM

  2. BIGTREV liked Gordon's post in the thread 22 mm push buttons.

    I finally found them. Allied Electronics. only $.40 each so the freight is more than the items. Thanks all.

    Dec 4, 2019 at 6:27 PM

  3. BIGTREV liked H0$$'s post in the thread 22 mm push buttons.

    Most are just thin aluminum or stainless steel sheet metal with a key tab to prevent rotating. Tin snips and Dremel time

    Dec 4, 2019 at 6:27 PM

  4. BIGTREV liked dnalot's post in the thread 22 mm push buttons.

    Just make one, that's what we do here. Mark

    Dec 4, 2019 at 6:25 PM

  5. BIGTREV liked Shopgeezer's post in the thread Attempt at a coolant mister.

    I am using Kool Mist. The recommendation is 4 oz per Imperial gallon. Lots of claims, good for machinery, environmentally safe etc....

    Dec 1, 2019 at 9:30 PM

  6. BIGTREV replied to the thread Attempt at a coolant mister.

    I like the sound of WD40, as I've got a couple of 5L cans on the self :) I rigged my mister up this afternoon, just messing with it,...

    Dec 1, 2019 at 9:29 PM

  7. BIGTREV liked blighty's post in the thread Attempt at a coolant mister.

    think the stuff i have is 1 part water 30-40 oil. but yes, normal rate. I use more of the white stuff as tend to open the taps up (as...

    Dec 1, 2019 at 9:15 PM

  8. BIGTREV replied to the thread Attempt at a coolant mister.

    Some interesting stuff of that Australian Metalworking Forum :) ..Cheers

    Nov 30, 2019 at 11:52 AM

  9. BIGTREV replied to the thread Attempt at a coolant mister.

    Nov 30, 2019 at 11:51 AM

  10. BIGTREV liked Ropetangler's post in the thread Attempt at a coolant mister.

    An interesting lot of posts on this topic on the Australian Metalworking Forum, a nice friendly forum too which I can recommend to all...

    Nov 30, 2019 at 11:50 AM

  11. BIGTREV replied to the thread Attempt at a coolant mister.

    "normal coolant...... the white stuff.".....Diluted at the normal rate? Thanks

    Nov 30, 2019 at 9:47 AM

  12. BIGTREV liked blighty's post in the thread Attempt at a coolant mister.

    for Aluminium WD40. steels, normal coolant...... the white stuff.

    Nov 30, 2019 at 9:45 AM

  13. BIGTREV replied to the thread Attempt at a coolant mister.

    What type of coolant, are people using? Cheers

    Nov 29, 2019
Show older items