Recent content by 10K Pete

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. 1

    Looking for input on a cylinder block corrosion issue.

    Distilled water is pure water, De-ionized water is hungry water. Nothing there but H2 O. And it's corrosive as you can't believe it! Ph can be 7 but it's ion hungry so any transferable ions are eaten up.
  2. 1

    New Washington member

    Great! Tell us what and how! Welcome from Port Townsend area.
  3. 1

    Adjustable drill.

    That's great! A real slap-yer-forehead idea. Could have used that a half dozen times.... Thank you for posting! Pete
  4. 1

    What kind of machine is this?

    It's an engine!
  5. 1

    Good morning from Olympia WA!

    I know there are more PNW's here but I guess they are a bit shy.....
  6. 1

    Good morning from Olympia WA!

    Hello from the north end of the sound, Port Townsend!
  7. 1

    Meh - Just a little clean up

    Nordland, Wa. here! There are a few of us around. Pete
  8. 1

    Electronic glo-plug ignition?

    Sounds like a PWM power supply....
  9. 1

    How do you seal joints?

    Permatex #1 and #2 and Aviation-Form-A-Gasket are shellac based and contain no silicone. None. They've been around since air was new and way before silicon. Pete
  10. 1

    Sealing boiler water level glass

    Most any model live steam seller will have the exact item. Especially the UK. That said, teflon tape rolled into a string or cord and then wound around the glass and pushed down into the packing gland works well. Pete
  11. 1

    Coloring calibrations on metal ruler

    Tire marking paint sticks have always been my go-to for filling engraved markings. Rub in then rub off the extra with a paper towel backed by a wood block. No block and the fill will be rubbed out especially shallower markings.
  12. 1

    South Bend heavy 10 vs....

    For equal 'capacity' machines, take the thousands you would spend on a cheapie and rebuild the SB to new. Ground, fitted, etc.... And you'd have a machine that will last longer than any two of the cheapies. And be rebuildable to new again. Yeah, always go for the old iron and when the numbers...
  13. 1

    Hello from WA state, USA

    Hello from the PNW! Welcome to the fun! Pete
  14. 1

    Health Update

    Thanks for the update. Hang in there friend! Pete
  15. 1

    Merry Christmas......

    Merry Christmas to all out there! Pete
Back
Top