source of scale spark plug wire for hit and miss models

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

chrsbrbnk

Well-Known Member
Joined
Jul 25, 2007
Messages
192
Reaction score
52
Is there a source of a scale looking high voltage wire for the spark plugs and maybe connectors too thanks, chris
 
I have just used cotton braid insulated wire which is about 3mm overall diameter so works OK on 1/2 to 1/4 scale engines, have not had any problems with the spark trying to jump. This looks like the 7 or 8mm braided HT wire. If you just want plain black or red then you can use leads for electrical testers or S/S sell it by the length. Anything looks better than the steel braided stuff on some of the cheap ignitions!

For connectors I use the flat brass type that clip over the top of the plug, solder wire to that and a bit of heat shrink to tidy it up. S/S do clips for various size plugs. S/S Machine & Engineering, LLC

PICT0488_zpsbcbe3f91.jpg

DSC02654_zpsji96haxl.jpg
 

Latest posts

Back
Top