Project of the Month built by mirek111

Help Support Home Model Engine Machinist by donating using the link above or becoming a Supporting Member.
Home Model Engine Machinist > Building Them > General Engine Discussion > help needed for ka counter

Thread Tools
Old 10-19-2016, 12:01 PM   #1
Join Date: Feb 2009
Posts: 59
Liked 2 Times on 2 Posts

Default help needed for ka counter

just installed a mitutoyo ka counter on a lathe and the counter only reads in full thousands in the x but in the y it reads half's so I would like to get into the parameters and see about changing the counter to read half thousands in the x. also the y reads correct as far as plus and minus but the x is reading the wrong way. so can anybody help with this problem?

bmuss51 is offline  
Reply With Quote

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Post counter Swifty The Break Room 4 01-11-2013 01:54 AM
Counter balance? robcas631 General Engine Discussion 3 10-19-2011 02:35 PM
Counter Clockwise Spindle Jack Software and Programming 5 10-09-2009 01:38 AM
Needed to counter sink a 4/40 socket head cap screw deere_x475guy Tools 15 02-02-2008 10:45 PM
Counter Sink Cutter Bernd Tools 2 02-01-2008 01:11 AM

Newest Threads

- Top - Member List