Last Activity:04-24-2017 12:31 AM
Likes Given: 2
7 Likes on 5 Posts
Posted in thread: Bluing steel part. on 01-17-2017 at 03:52 AM
I might be wrong but the blue that Chris (Clickspring) get on his parts is just surface and
very easily removed. Just too much handling will start to thinnen the blue surface. One of his
vidoes show i...
Posted in thread: Why a forum on disabilities? on 01-17-2017 at 03:09 AM
What a great thread. Thank you Gail. I was diagnosed with MS in 2004. I spent almost 4 years on
the couch/bed. I am 42 years young. I will not let this take over my life. I spend about 2-4
hours a day...
Posted in thread: Quarter Scale Merlin V-12 on 12-30-2016 at 03:33 AM
TerryIs great that everything worked out. I guess it give us better sense of how fragile our
bodies can be. A Happy Healthy New YearNelson Collar
Posted in thread: Quarter Scale Merlin V-12 on 12-21-2016 at 12:49 AM
TerryI do not know if being a member of the zipper club is that great but better than the
alternative. Pray all goes well, looking forward to see that little Merlin run.NelsonThe best
of a Christmas S...
Posted in thread: Quarter Scale Merlin V-12 on 12-02-2016 at 02:25 AM
TerryBest regards and a speedy recovery. Health is very important and I will be praying for
you. Don't worry the surgeon has probably done hundreds by now and with luck you will not need
Posted in thread: Quarter Scale Merlin V-12 on 12-01-2016 at 03:47 AM
TerryThis might be what you are looking for. Cut the pot chuck to exactly the size if the ring,
then you could face and cut the ID to exactly what you need. Maybe, check it out and it will
cost less t...
Posted in thread: Walking Beam Conveyor on 11-16-2016 at 10:17 PM
BrianAs usual very, very nice. I don't know how you come up with the ideas but do not stop.
They are the best of the best.CongradsNelson Collar
Posted in thread: Add your pin to our member map on 10-28-2016 at 03:30 PM
My name is Nelson and I live in Hawthorne, Florida, USA
Posted in thread: Quarter Scale Merlin V-12 on 10-24-2016 at 08:15 PM
TerryI am more lost now than what I was earlier. If the center rod is going to rotate any
amount. When it comes to rotation with the bearing on the crank is the normal thing, but to
rotate the rod end...
Posted in thread: Quarter Scale Merlin V-12 on 10-23-2016 at 09:49 PM
TerryI am not a pro but the one piece bearing I'm woried about. The two pistons move a little
bit and a solid bearing would hold it tight. Or am I looking at it wrong?Nelson