You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
With my table I used a t-slot cutter to mill out the slots so I could use the same mounting hardware as the mill. That's one of the good...
-
I've bought two tilting vises, the second one was just barely useable after putting some brass shims in one of the two circular ways...
-
While I hate to spend any more time on this angle table than I already did a few years ago, I still will post a bunch of pictures I took...
-
I have the bigger version of that thing. About the only thing going for it is the price...
Set the table at an angle and then sweep...
-
Great runner!
-
Hi all together
I`m presenting my fresh finished "Hoglet-V2" Engine, another one Made in Europe. This Engine has Cast iron Piston...
-
Starting on the cylinder today. The Stuart 5a cylinder casting is wonderful. It is spot on in dimensions and is wonderful to machine...