Last Activity:11-04-2015 12:56 PM
Likes Given: 5
262 Likes on 137 Posts
Posted in thread: 1/4 scale V8, first project. on 08-23-2015 at 12:55 PM
Johnny, I haven't got a full set of drawings available to send out I'm afraid.I can send you
some cad drawings of specific areas of the engine if this would help.Can I suggest you start
your own build...
Posted in thread: 1/4 scale V8, first project. on 08-12-2015 at 07:27 AM
I have had a look through my drawings and sketches, and realise that it would take far too long
to get them into a state where someone else could make a working engine from them.I'm afraid I
Posted in thread: 1/4 scale V8, first project. on 07-29-2015 at 09:10 AM
ok, whilst I am getting all the drawings together, could you send us some links to your
previous model building projects, to see if my plans would be suitable for you?Cheers, Keith.
Posted in thread: 1/4 scale V8, first project. on 03-26-2015 at 08:00 AM
Sure, no problem. Give me your e-mail and I'll send all 250 sheets of drawings and calculations
Posted in thread: 1/4 scale V8, first project. on 02-12-2015 at 01:10 PM
Hello Strangers.This may be of interest. shows the V8 again, with different silencers, and
progress on the V10.Turned out the V8 was only running on 7, so sounds a bit rough.Cheers,
Posted in thread: Another Radial - this time 18 Cylinders on 01-20-2015 at 10:53 PM
Terry, I've been following all the way, and would like to say, Absolutely Fantastic, amazing
Posted in thread: 1/3 scale V10, second project on 04-18-2014 at 10:03 PM
Keith are you still alive I hope nothing is wrong in your life really enjoyed your previous
build and have followed this one to !!!Yes, still here. The build is continuing on another
forum. I wasn't s...
Posted in thread: V12 Build on 04-15-2014 at 09:05 PM
Nice job Dick. I've been following all the way. Great to see another Vee engine firing
Posted in thread: 1/3 scale V10, second project on 01-09-2014 at 09:40 PM
Art, the half bearing on the sump cradle side has a small pin soldered in, similar to the con
rod bearings. I didn't do the block side as the oil way will be in this position. With the
bearings being ...
Posted in thread: 1/3 scale V10, second project on 01-07-2014 at 11:08 PM
Hi Bill, the cast iron was from Reeves in the UK. It was just plain extruded bar, not tube. I
had some more extruded cast which I think was from Chronos tools, which I've just used to make
the piston ...