VIEW MY

justlesh

Gift Premium Subscription To justlesh

Join Date:

07-10-2009

Last Activity:

11-30-2011 10:07 PM

2 Likes on 2 Posts 

LATEST ACTIVITY

  • Posted in thread: Shop dilemma. on 06-29-2010 at 10:39 PM
    Now thats purddy. I managed to sheet my ceilings and walls this spring but only got half
    painted before the urge kicked in to get machinery back in place. Regret it every time someone
    walks in. Congra...

  • Posted in thread: Tell me you wouldn't cry on 06-22-2010 at 01:19 AM
    Oh it really didn't get to me, as soon as I seen the hole I had the calculator in hand to
    figure out the mistake and as soon as I looked at the print I knew what I did. Already welded
    on 1 of the lift...

  • Posted in thread: Is it OK to ream 10.5mm into a 10mm hole? on 06-21-2010 at 09:05 PM
    I agree, not out of line at all, If you were to be working with a hole much smaller it might be
    too much. Just work slowly and clean out often, ream a little, back it out, clean reamer and
    hole, go a ...

  • Posted in thread: Tell me you wouldn't cry on 06-21-2010 at 08:45 PM
    I took a day off work today just to get some shop time and needed rest from the overtime of my
    job. It was pretty productive till this. I am pretty fluent in trig and knew I had plenty of
    meat as not ...

  • Posted in thread: D ogs on 06-17-2010 at 02:59 AM
    If a bomb went off in my yard I think Crusoe would think it's playing. He could care less if
    its thundering like crazy.

  • Posted in thread: Shop dilemma. on 06-17-2010 at 02:41 AM
    Use a vapor barier or house wrap on both inside and outside walls, tape seams, then use
    plywood. Put some outlets in the ceiling, I found them to be almost as necessary as outlets on
    the wall. Les

  • Posted in thread: Shop dilemma. on 06-15-2010 at 09:56 PM
    Well welcome aboard! Sounds like you are blessed with a fine woman willing to sacrifice some of
    her room for your hobbie. I'm also a supervisor, tool and die dept for a large corparation. I
    totally un...

  • Posted in thread: Parting off is chicken soup on 06-13-2010 at 09:18 PM
    I've been twisting handles for over a 1/4 century and parting or grooving is not an issue for
    me at all, but, I have worked with guys that just can't seem to get it down, I have even set
    them up and g...

  • Posted in thread: Trout Learns A Thing or Two on 06-06-2010 at 02:50 PM
    Chips in the carpet makes an impression on me, usually about the size of a hand :o Recently
    after a real long day in my shop I decided I should not only kick my shoes off but peeled down
    to my skivvys...

  • Posted in thread: Riser Blocks & Mounts Part 1 on 05-27-2010 at 09:13 PM
    Been concidering that exact same thing on mine. You just cant get under the bed and screws to
    clean anything out. I have held off this thinking of shortening the base or cutting out the pan
    and puttin...

FORUM SIGNATURE
Tis better to be thought a fool than to open mouth and remove all doubt
0 COMMENTS
POST A COMMENT


Newest Threads