VIEW MY

bazmak

BAZMAK

Gift Premium Subscription To bazmak

Join Date:

12-12-2012

Last Activity:

04-30-2017 11:32 PM

Likes Given: 567

658 Likes on 390 Posts 

LATEST ACTIVITY

  • Posted in thread: BAZMAK a second Lathe on 04-30-2017 at 11:32 PM
    Good morning Neils ,you will be looking to fit a diamond tool to the lathe ??As am I
    shortly.Will let you know by a post if its okThe compound is 50mm wide and the centre stud 25mm
    from the frontThere...

  • Posted in thread: BAZMAK a second Lathe on 04-30-2017 at 05:26 AM
    Ready to make chips even though I don't want to get the lathe dirtyFirst job is a half dozen
    brass thumbscrews to suit the QCTPand for this I made another tool holder to accept my mark3
    cut knurling t...

  • Posted in thread: BAZMAK a second Lathe on 04-29-2017 at 05:21 AM
    With the money I saved on the lathe I bought a qctp.The cheap small one made from aluminium.Now
    like me half an engineer would laugh at the thoughtof an alum toolpost.Its a no no. However I
    knew tis o...

  • Posted in thread: Help with a knurling tool on 04-26-2017 at 12:55 PM
    no problems john,im gratefull just don't know what I'm doing wrongand how to correct it

  • Posted in thread: Help with a knurling tool on 04-26-2017 at 06:42 AM
    Well I now have a surplus of knurled round bar so made a few thumbscrewsvarios sizes and
    shapes.Made and fitted one to the mark3 knurlhead to replacethe nyloc nut.Ideal,loosen off,
    feed the knurls to ...

  • Posted in thread: Help with a knurling tool on 04-25-2017 at 11:00 PM
    Thanks john,there were a set of 3 here is the brass oneI have lots of sample knurls now so will
    make a few thumb screwsAlways seem to want one but usually couldn't be bothered settingup for
    poor quali...

  • Posted in thread: Help with a knurling tool on 04-25-2017 at 07:13 AM
    A 2 min video take approx. 1 hr to upload ,so I don't do manyHowever this tool works so well
    that I have made 3 videos of knurling3 matls Steel 1214,alum 6061 and brass.Each video was one
    attemptdoing...

  • Posted in thread: Help with a knurling tool on 04-24-2017 at 05:03 AM
    Just finished Mark 3 and it works a dream.Perfect knurl first time Main points45o angle works
    the best and is the easiest to mount on adjacent faces of sq bar. I skimmed down to 25mm sq and
    drilled an...

  • Posted in thread: Help with a knurling tool on 04-23-2017 at 11:10 PM
    John,thanks for posting the video clip on rope knurling.The Klipspring videosare masterfully
    done and very informative.Will keep rope knurling in mindto try outNick ,yes I am looking at
    the importance...

  • Posted in thread: Help with a knurling tool on 04-22-2017 at 11:27 PM
    Good thinking.I bought a single straight wheel knurlier to get thesets of wheels included,i may
    be able to rework as you say.Also thinking about a vertical hinge pivot as the commercial ones
    to give a...

0 COMMENTS
POST A COMMENT


Newest Threads