Recent content by anday1

wow there are some great tips there ....i may lean on you in the future if thats ok many thanks andy

Penny has dropped as you show its the same for each crank....many thanks ..build starts next week so it will be some time before i get to crank but i will keep an update coming through all the best andrew

hi is the drawn picture the relation of the HP crank to the IP eccentrics? if you can show some more pics that would be really helpful Andy

have a look at one i made..this was cut in half for a center bearing

Thank you for taking the time to show these much appreciated. i am assuming that you would not try to make the IP eccentrics with the crankshaft?

Hi john not sure you could help with the measurement on the crank for the ceters machined the mill

just trying to get back 40 years to school on the maths lol

thanks for that andy i am looking to make the ip eccentrics and crankshaft out of solid bar using 2 separate throw pieces which i will align each end and help with jacking the crank to support it through making it. would you know the co-ordinances from the 120 degrees throw as i will center...

Great build can you tell me where you got the drain cocks from or how you made them many thanks

here's my Stuart twin launch 99% finished

friend of mine did a vid on it thought you might like to see it

congratulations on a great build and a great start. What joy it must have given you after such Alot of work. I am still trying in vain to get martins's single-cylinder engine working but to no avail while still working on his 4 cylinder boxer engine. Well done you should be very proud of your...

if it jumped its alive hahahahah nice set up peter

stunning work peter