VIEW MY

Vixen

Gift Premium Subscription To Vixen

Join Date:

01-21-2016

Last Activity:

02-09-2017 11:00 PM

Likes Given: 23

1 Likes on 1 Posts 

LATEST ACTIVITY

  • Posted in thread: Cheap Chinese Ignition? on 01-20-2017 at 08:27 PM
    Hi tornitore45You seem to have found the perfect solution for my project, a V8 engine with a
    single hall sensor and distributor. I discovered that these Chinese CDI units will not trigger
    from a Hall ...

  • Posted in thread: PatWankel Rotary Engine on 01-08-2017 at 04:48 PM
    Here we go again,look's like Manolis has invented the Wankel engine this time.

  • Posted in thread: Surface treatment for Aluminium on 05-18-2016 at 10:07 AM
    If you make an aluminium part with a thread in it and screw your part to be anodised then the
    thread will be protected MichaelBut make sure you use an aluminium bolt. If you use a steel
    bolt the anodi...

  • Posted in thread: Adding a High Speed Spindle to the Mill on 04-18-2016 at 09:12 PM
    I have often thought about mounting a Dremel 225 flexible extension onto the side of my mill
    for light engraving work. The Dremel 200 series Multitool runs between 15,000 and 35,000 RPM
    and has a 125 ...

  • Posted in thread: Demon Blower on 04-13-2016 at 08:31 AM
    Your illustration of the lobes, fully engaged, shows there is only a 0.1mm (0.004") separation
    between and surrounding the tip of the rotor lobes . Any backlash in the gears greater than
    0.1mm (0.004"...

  • Posted in thread: Demon Blower on 04-12-2016 at 08:20 PM
    What are the clearances when the lobes are rotated by a further 30 degrees and full meshed?Mike

  • Posted in thread: Thermite casting on 03-12-2016 at 09:06 AM
    Dont mess about with thermite.Do the job properly and nuke it.

  • Posted in thread: Quarter Scale Merlin V-12 on 02-28-2016 at 04:27 PM
    Use Permatex on a Packard Merlin and use Hylomar on a Rolls Royce Merlin.SimplesMike

  • Posted in thread: Naval gun on 01-21-2016 at 08:33 PM
    Looks good. A fine piece of naval firepower

0 COMMENTS
POST A COMMENT


Newest Threads