GailInNM

Administrator

Gift Premium Subscription To GailInNM

Join Date:

02-17-2008

Last Activity:

08-17-2017 2:01 AM

Likes Given: 109

281 Likes on 236 Posts 

    ABOUT ME

  • Albuquerque, NM USA
  • Retired engineer

LATEST ACTIVITY

  • Posted in thread: Difficulty with P.M. on 04-06-2017 at 04:25 AM
    Skyline, I sent you a PM to test. Let me know if you receive it OKGail in NM

  • Posted in thread: Hello on 03-29-2017 at 06:04 PM
    Welcome Jim.Lots of information here for the asking.Tell us a little about yourself, tools and
    experience. Any strong interests in a particular type of engine?Gail in NM

  • Posted in thread: thread size on 03-02-2017 at 12:00 AM
    I will be fine to take off 0.005 from the major diameter. The ANSI thread specification for
    3/16-24 shows it to be a NS (National Special) so it does not show up on a lot of thread
    charts, but the 0.1...

  • Posted in thread: An Introduction on 02-11-2017 at 04:28 PM
    Welcome to HMEM Eric.Looking forward to your videos and photos.Gail in NM

  • Posted in thread: Spam on 02-11-2017 at 04:16 PM
    We have been getting hits by spammers using personal messages for about a week. Unless you
    report them we Admins don't know about them so can't do anything.Please read post #2 on this
    thread from a fe...

  • Posted in thread: want to know the name of a saw on 02-10-2017 at 08:04 PM
    Assuming that you have not used one before, here are a few quick notes.1. The blade must cut on
    the pull stroke. The teeth face the handle.2. Select a blade that will give you about 2 teeth
    in the thi...

  • Posted in thread: want to know the name of a saw on 02-09-2017 at 10:50 PM
    A piercing saw is commonly known as a jewelers saw. Look like this?Gail in NM

  • Posted in thread: Spammer on 02-08-2017 at 05:34 AM
    We have had a rash of spam private messages. Some one registers, waits a few days then sends
    out a small pile of spam messages as private messages. We ban the spammer and lock then out as
    soon as we f...

  • Posted on TINY IC engine by Putputman in Downloads on 03/30/2015

  • Posted on Sparkplug cconstruction in Downloads on 11/06/2014

DOWNLOADS ENTRIES:
Following Stats
FORUM SIGNATURE
Gail in New Mexico, USA I would like to be the kind of person my dog thinks I am.
2 COMMENTS
Posted: 
October 8, 2015  •  04:59 PM
I would like to know how I can add a video to my thread from You-Tube
Posted: 
July 25, 2017  •  07:19 PM
Hello,

i found your great postings. At the moment i am building as an spare part a two lobe roots blower. The most of the work is finished. But i have a big problem with the design of the two lobe rotor.

I need a good way to design a two lobe rotor with variable contur. Maybe there is any possibility that you can take a look at my problem.
If it will work iam definitely will pay for it.

Kindest regards

Ben
POST A COMMENT


Newest Threads