Scraps and Solder Engine

Scraps and Solder Engine - IceFyre13th - s-s-engine-121.jpg
Member Since:
October 22, 2015

INFORMATION

Year
1950


GENERAL NOTES:

ENGINE DESIGN BASED UPON ARTICLE IN THE DECEMBER, 1950
ISSUE OF POPULAR SCIENCE (PAGES 196 and 197).

DIMENSIONS:
ARE GIVEN IN mm [INCHES].

SCALE IS 1 TO 1 IF PRINTED ON 11" X 17" PAPER (SEE SHEET 3).

DRILL SIZE #'s GIVEN AS NEEDED, OTHERWISE FRACTIONAL
DRILL SIZES USED.

MATERIALS:
SEE MATERIAL LISTED IN BILL OF MATERIAL.

ASSEMBLY:
SOLDER PARTS TOGETHER WITH SILVER SOLDER WHERE
INDICATED.

PRESS FIT PARTS SHOULD USE LOCTITE 620 RETAINING
COMPOUND

PISTON TO CYLINDER CLEARANCE SHOULD BE CHECKED FOR A
SHAKELESS BUT FREE RUNNING FIT.

TWO SCREW HOLES ARE INDICATED ON CYLINDER BASE 1,
THESE CAN BE USED TO SECURE BANDS USED TO HOLD
CYLINDER LAGGING WITH #4 SCREWS AND NUTS.

ENGINE INFORMATION:
FINISHED ENGINE WILL RUN FROM 2PSI AND UP TO 15 PSI
STEAM PRESSURE.
Tags
Uncheck a tag to remove it from this entry. Tags in bold were added by you.

Add Tags (Separate tags using a comma.)
Tags will be visible to all users.
Tags for this thread:
0 COMMENTS
POST A COMMENT